Serving 81 cities in 20 statesLicensed local plumbers
Written quote before any work(844) 618-1512
Plumber checking the drain pan under a leaking gas water heater during water heater leak repair in Kenmore, WA
Serving Kenmore, WA

Water Heater Leak Repair in Kenmore, WA

Water heater leak repair in Kenmore, WA that answers the first question fast: is this a part or the whole heater? The source is found, the repair is quoted in writing, and the heater is tested before we leave.

  • Tested before we leave
  • Leak traced to the exact part
  • Valves and fittings fixed on the spot

Source found first

The leak is traced to the exact part before anything is replaced.

Written quote first

Repairs and replacements are quoted in writing before work starts.

Licensed local plumbers

Water heater work by licensed plumbers in your area.

Leaking water heaters only

One specialty: tank and tankless units that are losing water.

Craftsman home with a service van outside, booked for water heater leak repair in Kenmore, WA
Kenmore, WAKing County
Local water heater leak specialists

Trusted Water Heater Leak Repair in Kenmore, WA

In Kenmore, water heaters are usually in the garage or a utility room, strapped for seismic safety. Leaks at the top connections and relief valve are the common calls.

1ZIP code covered
23,594Kenmore residents
KingCounty

About 23,594 people live in Kenmore, spread over ZIP code 98028, and each of them is on our map: 98028.

Call (844) 618-1512
Where it leaks

Where Water Heaters Leak in Kenmore

Dripping relief valve, a common reason to book water heater leak repair in Kenmore, WA

Dripping relief valve

The valve opens at 150 psi or 210 °F. A steady drip means a worn valve or a pressure problem.

Weeping drain valve, a common reason to book water heater leak repair in Kenmore, WA

Weeping drain valve

Plastic drain valves wear out. A new brass valve usually ends it.

Water from the tank body, a common reason to book water heater leak repair in Kenmore, WA

Water from the tank body

Rust and water at the seam or base mean the tank has corroded through. That one gets replaced.

Leak at the expansion tank

The small tank on the cold line, or its connection, starts to drip.

Rust-colored water

Rusty hot water or rust streaks on the tank can mean corrosion inside.

Tank seam or bottom leaking

Water from the steel tank itself, the one leak that means replacement.

Not sure where yours is coming from? Book water heater leak repair in Kenmore, WA and the source is traced before anything is replaced.

Water pooling at the base of the tank, traced to its source during water heater leak repair in Kenmore, WA
Part or tank?The answer decides the cost
Repair or replace

Repair or Replace in Kenmore?

Valves, fittings, connectors and gaskets get repaired, whatever the heater's age. Water from the tank body, the bottom seam or from inside the threads of a tank fitting means the steel has corroded through, and that heater is replaced.

Tell us how old the heater is and where it is wet. That decides whether water heater leak repair in Kenmore, WA or a replacement makes sense, and you will be told which. Call (844) 618-1512.

Call (844) 618-1512
Estimated cost

Water Heater Leak Repair in Kenmore, WA Cost

Budget an estimated $150 to $600 for most water heater leak repair in Kenmore, WA. The range moves with the part, the access and the type of heater; a failed tank is replaced at an estimated $1,200 to $3,500.

Leak diagnosis

$100–$250
Estimated service call
  • Pan, condensate and relief line checked
  • Warranty status checked
  • A straight repair-or-replace answer
Call for a free quote
Most calls

Valve & fitting repairs

$150–$600
Estimated · most leaks
  • Drain valve swapped for brass
  • Element or valve gasket resealed
  • Relief (T&P) valve replaced
Call for a free quote

Tank replacement

$1,200–$3,500
Estimated · when the tank leaks
  • Pan, expansion tank and straps where code calls for them
  • Old tank drained and hauled away
  • Written quote before the swap
Call for a free quote

Need Water Heater Leak Repair in Kenmore, WA? Stop the Drip Today

The sooner the leak is traced, the more likely it is a valve and not a new heater.

Call (844) 618-1512
Local data

Kenmore Homes by the Numbers

9,362housing units
1984median year built
68%single-family homes
$869,800median home value

About 50% of homes in Kenmore are heated with gas and 48% with electricity, so a call can mean a gas unit or an electric one. Roughly 68% of homes are single-family and the rest are apartments and townhomes, so a leaking heater may be in a utility closet or a shared mechanical room. The median home was built in 1984 and is valued around $869,800, and about 70% of homes are owner-occupied, which shapes whether a repair or a full replacement makes sense.

Kenmore covers about 6.2 square miles and holds roughly 23,594 residents, around 3,836 per square mile: suburban in density, with a mix of detached homes and townhomes. It is number 40 by population of the 209 Washington places on our service list.

Source: U.S. Census Bureau, American Community Survey 2019-2023 5-year estimates for Kenmore, WA.

Coverage

ZIP Codes We Cover in Kenmore

About 23,594 people live in Kenmore, spread over ZIP code 98028, and each of them is on our map: 98028.

  • 98028

Nearby Cities We Serve

FAQ

Water Heater Leak Repair in Kenmore, WA FAQs

Water in the drain pan under the tank, a question answered in these water heater leak repair in Kenmore, WA FAQs

Your question not here?

Ring us with it. A plumber who handles leaking heaters answers, and the quote costs nothing.

Call (844) 618-1512
How much does water heater leak repair in Kenmore, WA cost?

Most jobs for water heater leak repair in Kenmore, WA cost an estimated $150 to $600 when a valve, fitting or connector is leaking. If the tank itself has failed, replacement is estimated at $1,200 to $3,500. Replacements include seismic straps, which are part of the written quote.

Can I still use water if my water heater is leaking?

With the heater's cold supply valve closed, the cold water in the rest of the house still works. You will not have hot water until the leak is fixed.

Is a leaking water heater an emergency?

Spraying or pouring water is: shut the heater off and close its cold supply straight away. A slow valve drip is urgent, not dangerous, and should be booked within a day or two.

How long will a water heater last once it starts leaking?

If it is a valve or fitting, it gets fixed and the heater carries on. A tank leak never improves; some drip for months and some fail suddenly, so it shouldn't be left.

New tank with drain pan, expansion tank and straps, installed when water heater leak repair in Kenmore, WA found a failed tank

Book Water Heater Leak Repair in Kenmore, WA Today

Ring (844) 618-1512 and say where the water is showing. The likely fix and its estimated cost come back on that call.

Call us

Speak With a Water Heater Leak Specialist in Kenmore

Call now

(844) 618-1512

One call covers the likely cause, an estimated cost and a visit time.

Covering Kenmore

98028, plus nearby parts of King County.

More cities in Washington
Call (844) 618-1512